Table Saw Extension Table Idea

esmith2024 · Post by **esmith2024** » Mon Aug 19, 2024 12:25 pm

I designed a table extension for my Mark 510. It consist of electrical conduit, a piece of 9mm birch plywood, 6 3D printed parts, and a few #6 screws. Some of the advantages of this design are: it can be used as an infeed and/or outfeed table, it tilts with the table saw table, can be made in any size to fit the need, and possible can be used on the extension tables.

If interested in getting the 3D part files, let me know.

JoeSark · Post by **JoeSark** » Tue Aug 20, 2024 6:59 am

That looks really slick! Looks like it would also be possible to use it with the 520 table.

roy_okc · Post by **roy_okc** » Tue Aug 20, 2024 7:42 am

Great idea, thanks for joining the forum and posting a project as your first post! It's hard to tell from the last photo, but I assume that the printed parts are indeed below the level of the table's top? Does the board sit below the bottom of the miter gage slot so the miter bar will pass over the board?

stihlsawer · Post by **stihlsawer** » Fri Aug 23, 2024 3:04 pm

That is one slick setup! Nice work!

esmith2024 · Post by **esmith2024** » Fri Aug 30, 2024 9:45 am

The parts and the plywood sit below the Table Top. I didn't add slots for the miter gauge; however, using 9mm plywood provides clearance so slots could be added if the plywood was supported underneath the slots.

roy_okc · Post by **roy_okc** » Fri Aug 30, 2024 10:06 am

esmith2024,

Are you open to making the models available, paid or otherwise? I'd sure like to try the setup on my SSs.

dusty · Post by **dusty** » Mon Sep 02, 2024 4:53 pm

Now that is really slick and I'd bet very marketable. Offer me a set, please.

Ed in Tampa · Post by **Ed in Tampa** » Mon Sep 16, 2024 10:10 am

Now this is the best idea I have seen in a loooooong while. Great idea!

esmith2024 · Post by **esmith2024** » Fri Oct 25, 2024 7:41 pm

I had a few request for the 3d printed files so I've attached the STL files here. If this doesn't work let me know and I'll try another approach to getting the files out there.
BR
Ed S

JPG · Post by **JPG** » Thu Oct 31, 2024 6:05 pm

No stl files attached. ADMIN ??????

Shopsmith Forums

Table Saw Extension Table Idea

Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea

Re: Table Saw Extension Table Idea