Set Up Gauge

reible · Post by **reible** » Sun Apr 05, 2009 8:43 pm

The part number is for the setup gauge for aligning the front and rear rails on the 520 tables.

Ed

dusty · Post by **dusty** » Sun Apr 05, 2009 8:45 pm

wholeshoe wrote:Apologizes for all the confusion.

The PN is 521097 and it is called a setup & alignment gauge. It is a 3" long plate of aluminum with a 90 degree lip at one end.

It cost $3.47 and when ordering a saw arbor I though why not the shipping will be the same anyway...

The thought of it replacing the allen wrench came from laying this flat on the saw table and runing the sanding disc round to see where the high spot was.

Does that help you guys? I hope so sorry for the unclear first post.

Art

Nope, we were all wrong. The setup gauge (521097) is used to align the 520 rails to the 520 table.

Check out the following thread. I think it will answer your questions.

http://www.shopsmith.net/forums/showthr ... ment+gauge

wholeshoe · Post by **wholeshoe** » Sun Apr 05, 2009 8:54 pm

well i dont even have a 520. But anyhow I might someday and I'll keep it around.

Art

JPG · Post by **JPG** » Sun Apr 05, 2009 9:22 pm

Your Turn Dusty! 520 is an unknown to me!