Sanding shaping fence for 520

mbcabinetmaker · Post by **mbcabinetmaker** » Fri Apr 24, 2009 9:51 pm

Anyone know how this fence attaches to the 520 table? I would like to see a picture if possible.

http://www.shopsmith.com/ownersite/cata ... rfence.htm

charlese · Post by **charlese** » Fri Apr 24, 2009 9:58 pm

Since the 520 table is a 510 table with new rails, the top surface is the same. There are two holes in the table that accept the screws to bolt down this fence. It's pretty neat - in that the square nuts fit under the table and fit up against a rib. They won't turn when tightening from the top.

mbcabinetmaker · Post by **mbcabinetmaker** » Sat Apr 25, 2009 7:41 am

Thanks Chuck I think I need one!:)

Mark