This is a forum for intermediate to advanced woodworkers. Show off your projects or share your ideas.
Moderator: admin
rocke1
Gold Member
Posts: 31 Joined: Thu Nov 09, 2006 2:11 pmLocation: Virginia Beach Va
Post
by rocke1 Tue Jun 09, 2009 11:59 am
Cutting 1/8 by 3/4 in stock is done with a 110 tooth steel blade and sliding crosscut sled that provides a safe and clean cut. Keys for a small box to reinforce the mitered corners is shown[ATTACH]4900[/ATTACH]
Attachments
Thin.JPG (62.86 KiB) Viewed 1553 times
charlese
Platinum Member
Posts: 7501 Joined: Fri Dec 08, 2006 10:46 pmLocation: Lancaster, CA
Post
by charlese Tue Jun 09, 2009 8:31 pm
Showing your method of cutting small pieces safetly on the table saw is appreciated, Rock!
Octogenarian's have an earned right to be a curmudgeon.