Binding Quill

[JPG]

Perhaps I overstated reality. It requires some force to get the belt off the sheave(pulley). Requires pulling hard in a small space.

[JPG]

I would believe the hole and screw holes in the belt housing looks to be a better place for the switch and looks like it was there at one time. If so, why did you move it to the motor pan which is lower on the headstock and looks harder to find. Did you look at any of the red paddle to turn off type switches which you can hit with your knee or hand in case of quick turn-off?

I bet he did not like it on the belt housing. It interfered with taking the cover off. I like all that stuff being in one assembly(the motor housing). If possible, a bit higher WOULD be 'better'(easier to get to).

[rayjack]

I would believe the hole and screw holes in the belt housing looks to be a better place for the switch and looks like it was there at one time. If so, why did you move it to the motor pan which is lower on the headstock and looks harder to find. Did you look at any of the red paddle to turn off type switches which you can hit with your knee or hand in case of quick turn-off?

I first installed the switch on the belt housing, but then realised that if I wanted to remove the belt housing I would have to disconnect the wires to the switch, or increase the length of them to allow the housing to be pulled away. Where it is now keeps the wiring from the motor to the switch short and does not have to be disconnected each time. Although it looks "harder to find" it is not. I find that if I drop my left hand down while working on the saw table the switch is just at the right height. The red OFF button protrudes proud of the casing and is very easy to hit if necessary.
Ray

[rayjack]

Great Idea! Where does one get them?

I got it from my local mail order tool store (Axminster Power Tools in Devon - come on over!)

Ray