How to get sanding paper disc off?

jmcniece · Post by **jmcniece** » Fri Aug 03, 2007 12:15 am

I'm trying to replace my sanding discs on the 12" disc sander (shopsmith of course) but am having a difficult time. I have the sticky type and not the velcro one and they've been on there a very long time. Is there a trick or special chemical that makes getting these discs off easier? The sandpaper portion has torn off but tons of backing and adhesive still remain.

Thanks in advance for any help -
Jeff

a1gutterman · Post by **a1gutterman** » Fri Aug 03, 2007 1:17 am

Hi jmcniece,

There are other threads addressing this subject. Click on this link to see one of them: https://forum.shopsmith.com/viewtopic.php?t=292&highlight=sand+paper+removal

Hope this helps:D .

jmcniece · Post by **jmcniece** » Fri Aug 03, 2007 3:54 pm

Sorry I missed the other thread - I did honestly look (not well enough though - obviously)

a1gutterman · Post by **a1gutterman** » Sat Aug 04, 2007 2:47 am

You are welcome, and welcome to the forum.

popstoyshop · Post by **popstoyshop** » Mon Aug 06, 2007 1:36 pm

Hi,

This can be a problem. My method is god awful. First I rip what I can off the disc. Next I have a chinese 1 in. chisel (somewhat dull) that I scrape the disc with (under power, but slow). Last I wash the disc with mineral spirits.

I know this is a labor intensive, but I've not found a better method.

Bill G.

dusty · Post by **dusty** » Mon Aug 06, 2007 1:57 pm

At the risk of repeating someone elses post (suggestion), I use heat. Most of the time, I can just put it out in the sun for awhile. When that isn't practical, I heat the disk w/paper in the oven.

Reference this thread, previously referenced in this thread.

http://www.shopsmith.net/forums/showthr ... er+removal

robg · Post by **robg** » Sun Aug 12, 2007 12:21 am

Also at the risk of repeating what was already said in the other thread, Rick Young, the traveling academy instructor, suggested by hot water. He has several reasons for thinking water was better than heat guns, ovens, and any of the other methods that people seem to have luck with.

popstoyshop · Post by **popstoyshop** » Sun Aug 12, 2007 1:20 pm

Hi Folks,

I've never tried the heat method, but it sounds like a winner.

I have noticed that some brands of sandpaper stick better than others. I would rather have the more stick than less. (I don't like floppy edges) and deal with the removal problem when I have to.

Bill G.

al_killian · Post by **al_killian** » Sat Aug 18, 2007 12:50 pm

What about useing mineral spirits? I use this to remove any residue on my corain after scrolling and it only take a few minutes to desolve all the glue.

pepe · Post by **pepe** » Tue Aug 21, 2007 5:20 pm

i just mine recently--it was on there for over 10 years --i used a heat gun --once it got soft i kept moving the gun ahead of the work--it worked great- just be careful if you use a scraper not to scratch the metal--good--luck

Shopsmith Forums

How to get sanding paper disc off?

How to get sanding paper disc off?

Sand Paper Removal

Thanks - the heat worked!!!

Getting Sandpaper Off The Disc

How to Get Sanding Paper Off Disk

Sandpaper Disc Removal