10er quill

indianabob · Post by **indianabob** » Fri Jan 22, 2010 4:42 am

on my 60 yr old er 4 digit serial,, ive noticed my quill is a little loose,, i was thinking of drillingm three holes and using brass bolts with stop nuts to hold the quill steady,, any suggestions,,,indianabob

heathicus · Post by **heathicus** » Fri Jan 22, 2010 9:54 am

How is it lose? Is the play from side to side or in and out? And I'm not sure I understand the fix either. Wouldn't that keep the quill from extending?

Are the bearings original? Perhaps the fix would be as simple as replacing them? Before you start drilling holes in it, I'd want to identify the actual cause of the problem.

mickyd · Post by **mickyd** » Fri Jan 22, 2010 10:28 am

indianabob wrote:on my 60 yr old er 4 digit serial,, ive noticed my quill is a little loose,, i was thinking of drillingm three holes and using brass bolts with stop nuts to hold the quill steady,, any suggestions,,,indianabob

Your proposal would be an extreme re-engineer for what could be a problem with a more simple solution. Not saying your idea may not have merit but understanding the true root cause is critical for the 'correct' fix. Try to elaborate more and the flood gates of suggestions will open.

indianabob · Post by **indianabob** » Fri Jan 22, 2010 8:11 pm

rule no one, first use a dial indicator before having aligator mouth superseed humming bird butt,,,,,looks like its the bearings in the quill,,,any problems anticipated on inspection and removing bearings..indianabob

JPG · Post by **JPG** » Sat Jan 23, 2010 12:57 am

indianabob wrote:rule no one, first use a dial indicator before having aligator mouth superseed humming bird butt,,,,,looks like its the bearings in the quill,,,any problems anticipated on inspection and removing bearings..indianabob

Make sure all 'setscrews' are loosened/removed prior to using bearing puller(yes you will need a bearing puller).

Mickyd, take it from here!!!!

indianabob · Post by **indianabob** » Sat Jan 23, 2010 7:09 am

i dont have any "paper" on my machine,, are the quill bearings common, or is this going to be aproblem finding them,,,indianabob,, old and grey

mickyd · Post by **mickyd** » Sat Jan 23, 2010 7:29 am

Bearings are commercially available and indicated in the first link below. These 2 posts below will give you an idea what your up against. Questions??.....just ask.

Bearing removal
https://forum.shopsmith.com/viewtopic.php?p=41515&postcount=97

Bearing installation
https://forum.shopsmith.com/viewtopic.php?p=47789&postcount=206