tdubnik wrote:First thing I did was to try and measure the problem. I placed the table upside down on a flat cast iron table. I then zeroed out an angle gauge to the table top and measured the tubes. The front tube was within .1 degree of vertical but the back tube was off by 1.4 degrees.
Next I removed the table from the trunion to see if that made a difference. It did not. Still off the same amount. I used a Starret straight edge to make sure the tubes were straight. Both were absolutely straight. This really only leaves a couple of possibilities. Either the casting is warped or not bored straight.
At this point I figure I'll wind up having to replace the leg casting but let's try something else first.
I decided to see if I could stretch it out with my spreader clamp. The nominal between the legs center to center should be 15 1/2". I used the spreader to stretch them out to almost 16". There was some spring back but the legs were closer to a fit. I stretched them out to about 16 1/4" and left them like that for a while. When I removed the clamp the legs fit the carriage with only a gentle tug. No more spreader clamp to install the table.
I was afraid to stretch it anymore for fear of breaking the casting. I can now install the table by hand and with the table lock loose it will fall to its lowest position by its own weight. I'm going to call this good enough.
I reinstalled the table to the trunions. I then aligned the main table to the saw blade and I'm back in business.
Great!!!!!
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
tdubnik wrote:... At this point I figure I'll wind up having to replace the leg casting but let's try something else first.
I decided to see if I could stretch it out with my spreader clamp. The nominal between the legs center to center should be 15 1/2". I used the spreader to stretch them out to almost 16". There was some spring back but the legs were closer to a fit. I stretched them out to about 16 1/4" and left them like that for a while. When I removed the clamp the legs fit the carriage with only a gentle tug. No more spreader clamp to install the table.
I was afraid to stretch it anymore for fear of breaking the casting. I can now install the table by hand and with the table lock loose it will fall to its lowest position by its own weight. I'm going to call this good enough.
I reinstalled the table to the trunions. I then aligned the main table to the saw blade and I'm back in business.
Nifty fix!!! I like to think that's how I would have done it!
Octogenarian's have an earned right to be a curmudgeon.
Chuck in Lancaster, CA
If (and that is what I strongly suspect) the casting is bent. Be sure to check that the table is flat. A bent casting could have warped the table.
Ed Friedl
