Pro Planer In and Out Feed Roller Replacement

keepatightline · Post by **keepatightline** » Mon Oct 11, 2010 2:22 pm

I must replace the outfeed roller on my model 514300 pro planer but I don't see how to remove it without removing the back side plate. Does anyone know the "trick" needed to avoid complete disassembly? Thanks in advance.

SDSSmith · Post by **SDSSmith** » Mon Oct 11, 2010 2:58 pm

The replacement rollers come with instructions. Did you lose them?

SDSSmith · Post by **SDSSmith** » Mon Oct 11, 2010 3:13 pm

To be clear, are you trying to avoid removing the planer from the stand or ?? Hopefully, you have the instructions that Shopsmith includes with the replacement rollers. If not, email me.

keepatightline · Post by **keepatightline** » Wed Oct 13, 2010 10:01 am

First, thank you for responding. Facts are I was just trying to find out how to "lift out" the roller. I tried getting it out through the trapazoid shapes but was repeatedly unsuccessful. HOWEVER, this morning I walked out with a cup of coffee in one hand, barely awake, and got lucky. It lifted right out through that opening. I think I'm set for now. Again, thanks for responding.

tunznath · Post by **tunznath** » Wed Oct 13, 2010 6:15 pm

Hi
I think I may have to replace one in the near future, so any OTHER info will be much appreciated

thanks