Recently purchased a Shopsmith 10er. Over all it is in good shape. Need to replace the head stock pulley and the speed changer belts. Does any one know a source for these parts?
James
10er replacement parts
Moderator: admin
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
The belts can be found at most auto supply places. The pulley is more difficult since the bore is non-standard.(13/16???? 27/32????) Other than that, it is a 2/3/4 inch cone pulley.jbooher wrote:Recently purchased a Shopsmith 10er. Over all it is in good shape. Need to replace the head stock pulley and the speed changer belts. Does any one know a source for these parts?
James
I will let 'someone else' tell you the proper length(not sure/22.5/24.5?? one each).
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange