Been awhile since I've posted, but finally have time (and a reason) to jump back online. The move from Denver to Portland went well. Everything seems to have arrived in pretty much the same condition in which it left - which is quite a blessing...
So, now I'm in the process of putting a few of the old machines back together from the pieces they were shipped as and I've noticed something about the headrests. They aren't uniform left side to right side.
On one side, the casting for the knurled bolt protrudes quite a bit. On the other side it is almost "flush" with the rest of the headrest. Does anyone know which side faces out? I did a quick search online, and I'm seeing pictures with all sorts of orientations. Any advice?
Thanks!
Doug
Portland, OR
Headrest orientation for the 10er
Moderator: admin
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Protrusion 'out'. Mount the headrest with 1/8" clearance to the tie bar(it must pivot past the top of the headrest).
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange