Way Tube dents...

wdphillips · Post by **wdphillips** » Tue Mar 22, 2011 5:27 pm

The top Way Tubes on my newly acquired SS 510 has quite a few dents. I presume these came from the previous owner overtightening the head.

Should I replace the top tubes or can I get by with the dents?

dusty · Post by **dusty** » Tue Mar 22, 2011 6:43 pm

I would start by trying to use the way tubes unless you have money you need to rid yourself of.

But seriously, if you rotate the tubes so that the top side (where the wedge locks contact) are on top, these should work fine.

Realizing that we can not see the dents.

JPG · Post by **JPG** » Tue Mar 22, 2011 8:13 pm

dusty wrote:I would start by trying to use the way tubes unless you have money you need to rid yourself of.

But seriously, if you rotate the tubes so that the top side (where the wedge locks contact) are on top, these should work fine.

Realizing that we can not see the dents.

Nor will you if you rotate then enough!:D;)

farley · Post by **farley** » Tue Mar 22, 2011 9:37 pm

another option would be to flip them with the bench tubes. they are different sizes so a pair would have to be cut in order to be 3/4 of an inch differrent. Only down side to this method would be an SS a little shorter, but not by much, if I am correct

JPG · Post by **JPG** » Wed Mar 23, 2011 12:36 am

farley wrote:another option would be to flip them with the bench tubes. they are different sizes so a pair would have to be cut in order to be 3/4 of an inch differrent. Only down side to this method would be an SS a little shorter, but not by much, if I am correct

Don't try that with a 'Greenie' or Gilmer 'Goldie'.

bhurley · Post by **bhurley** » Wed Mar 23, 2011 6:52 am

Or contact me for a replacement set of tubes.

ddvann79 · Post by **ddvann79** » Wed Mar 23, 2011 1:56 pm

wdphillips wrote:The top Way Tubes on my newly acquired SS 510 has quite a few dents. I presume these came from the previous owner overtightening the head.

Should I replace the top tubes or can I get by with the dents?

If the tubes are straight, I would just flip them over. I had some pretty severe pitting on the tops of my tubes and that was a satisfactory solution for me.