"New" part machine.

jcraigie · Post by **jcraigie** » Thu Mar 24, 2011 8:28 am

Yesterday I picked up a new machine to use for parts. We're also going to you any cash we raise by selling parts to buy more Shopsmith stuff that we need. I gave $50 for it, not bad but it is in rough shape. It was being used as a metal lathe.

This is a cross vise that bolts to the way tubes and whole load of different drill chucks.
[ATTACH]12377[/ATTACH]

[ATTACH]12378[/ATTACH]

jcraigie · Post by **jcraigie** » Thu Mar 24, 2011 8:31 am

[attach]12379[/attach]

[attach]12380[/attach]

jcraigie · Post by **jcraigie** » Thu Mar 24, 2011 8:33 am

When I go there he immediatly started it up and it ran beautiful and smooth but look at the cord! No way would I run it with that cord.
[ATTACH]12381[/ATTACH]

jcraigie · Post by **jcraigie** » Thu Mar 24, 2011 8:34 am

Not sure what happened to the piece on the end of the quill

[ATTACH]12382[/ATTACH]

dusty · Post by **dusty** » Thu Mar 24, 2011 8:38 am

You got your money's worth in chucks and you have a great machine to be used for a restoration to say nothing about the vise.

Power cord looks great too.

:rolleyes:

jcraigie · Post by **jcraigie** » Thu Mar 24, 2011 8:39 am

I did get a jig saw in decent shape. Where do I get blades for this? I know some of you guys have a solution blades.[ATTACH]12384[/ATTACH]

[ATTACH]12385[/ATTACH]

[ATTACH]12386[/ATTACH]

[ATTACH]12387[/ATTACH]

[ATTACH]12388[/ATTACH]

[ATTACH]12384[/ATTACH]

jcraigie · Post by **jcraigie** » Thu Mar 24, 2011 8:41 am

Various other "modified" parts.

[ATTACH]12389[/ATTACH]

[ATTACH]12390[/ATTACH]

[ATTACH]12391[/ATTACH]

[ATTACH]12392[/ATTACH]

jcraigie · Post by **jcraigie** » Thu Mar 24, 2011 8:46 am

The vent plate... an early 1955

[ATTACH]12395[/ATTACH]