beeg wrote:Dusty, here's a link for the maint. kit and it lists whats in it.
http://www.shopsmith.com/ownersite/catalog/mvmaint_helpkit.htm
Thank you, beeg. That clears up some of my questions.
It appears there are no tapered screws for the miter bar and I am confused about the "setscrews" for the motor pan. Has this list been upgraded for the PowerPro (is that what these are)? There also is no washer for the miter bar.
I also have a much longer list of setscrews that I compiled some time back by going through all the parts lists and pulling out p[art numbers and descriptions. Some of the descriptions were verified by actually pulling the set screws from my machines to see what was there. There appears to be contradictions galore. I suppose this might be why one person says serrated and the next says cup point and the next says flat, etc, etc.
Is there any unique information in the Mark V Alignment and Maintenance Manual; is this something I should order since I have never seen this one?