Jacobs Multi-Craft Chuck Failure

judaspre1982 · Post by **judaspre1982** » Thu Apr 21, 2011 1:40 pm

================================
DT aka Agent Orange is a POS
Liar Liar his wonky comb over is on fire

wannabewoodworker · Post by **wannabewoodworker** » Thu Apr 21, 2011 2:43 pm

That sucks! I had to demolish a Shopsmith chuck recently as it became permanently attached to my Mark VII quill. After much cutting and grinding I finally got it off the quill but not without scarring the end of the quill some. The quill seems fine and works fine but it doesn't look too good anymore. I will get another quill at some point to replace this battle damaged one but for now it works.

JPG · Post by **JPG** » Fri Apr 22, 2011 12:44 pm

Since you already have the skill to disassemble it, contact jacobs re the availability of replacement jaws.

http://www.jacobschuck.com/emailform.aspx

P.S. http://www.mcmaster.com/#catalog/117/2409/=bzlao4

I have been 'waiting' since November for 20N jaws(first shipment from 'far east' was not to 'spec'.

I do not know what if any jaws fit the 'mastercraft' versions.

Might be 'less expensive' to procure used on e-bay!

judaspre1982 · Post by **judaspre1982** » Fri Apr 22, 2011 12:49 pm

=====================================

JPG · Post by **JPG** » Fri Apr 22, 2011 12:55 pm

judaspre1982 wrote:Never thought about that.
Thanks for the link JPG.

Dave

Geeeez! Your echo is FAAAAAAST!:D

JPG · Post by **JPG** » Fri Apr 22, 2011 12:56 pm

Check original post for "ps"!