Mark VII vrs ER parts

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue May 03, 2011 10:23 pm

What parts or accesories of the Mark VII will fit the ER if any?

JPG · Post by **JPG** » Wed May 04, 2011 12:13 am

Shop_Smith_Poppi wrote:What parts or accesories of the Mark VII will fit the ER if any?

Quill and shaft the same dimensions. Saw 8" vs 9". Spt's no mount/coupling(can be created).

damagi · Post by **damagi** » Wed May 04, 2011 1:40 am

yeah...there isn't much the same between the two.

Oh, the miter guage should fit as well

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Wed May 04, 2011 1:57 am

JPG40504 wrote:Quill and shaft the same dimensions. Saw 8" vs 9". Spt's no mount/coupling(can be created).

Sorry for my ignorance but what does Spt's mean?

jcraigie · Post by **jcraigie** » Wed May 04, 2011 3:08 am

Sprecial Purpose Tools -> bandsaw, jointer, belt sander, etc.

SDSSmith · Post by **SDSSmith** » Wed May 04, 2011 9:58 am

damagi wrote:yeah...there isn't much the same between the two.

Oh, the miter guage should fit as well

I doubt it. The miter bar on the 10E/ER is 3/4" wide, too wide for a Mark VII's miter slot.

robinson46176 · Post by **robinson46176** » Wed May 04, 2011 10:40 am

This sounds like the way that mechanics always talked about Fords and Chevy's.
They said that almost any Chevy transmission would bolt onto about any Chevy engine and that mounts would usually fit.
On a Ford on the other hand they said that you could not take the antifreeze out of one Ford and put it in another...

On today's cars of course all bets are off across the board.

.