Part 1 : Taking inventory an initial tear down my 10ER

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue Jun 07, 2011 10:58 pm

VII Table

VII Tail Stock I think?

SDSSmith · Post by **SDSSmith** » Tue Jun 07, 2011 10:59 pm

Shop_Smith_Poppi wrote:So I decided that today was the day I start redoing my 10ER. I started taking her apart and took some pictures of each of the parts I have.

You may recall in a separate post I made earlier that I had some 1 ¾ “muffler pipe I was going to use to the way tubes with. Well I tried out the pipe and it is just about 1mm to big and will not fit. So now Plan “B” Not sure what that is yet but I think it will consist of a drill and a expandable plug. More on that later.

Now back to the tear down. I started with the parts that were not attached to the ER already. Here is a few pics.

I am not sure if this is for the ER or not but it was in my box of parts. More parts in next post.

Miter gauge looks like it is from a Mark V or Mark VII though some folks have adapted the pistol grip to 10ER miter bars. Check the fit in the miter slots. The extension table is from a 10ER. 10E's came with a bracket and you made the top from wood.

SDSSmith · Post by **SDSSmith** » Tue Jun 07, 2011 11:00 pm

Shop_Smith_Poppi wrote:

Mark VII Router Table.

Based on the tiebar, I would say Mark VII.

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue Jun 07, 2011 11:01 pm

ER Table

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue Jun 07, 2011 11:02 pm

SDSSmith wrote:Based on the tiebar, I would say Mark VII.

Yes it is I am hoping to make some different legs for it and mount it on my ER. They will have a dog leg in them I suspect.

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue Jun 07, 2011 11:04 pm

Mark VII Lathe rest

Lathe rest that came with my ER

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue Jun 07, 2011 11:05 pm

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue Jun 07, 2011 11:07 pm

Its rusty but but it works fine.

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue Jun 07, 2011 11:10 pm

So that is all my parts I have at this moment. I have a ER lathe Rest on the way if I can remember to mail out the the shipping cost.

And I am supposed to have some other parts coming in mail as well.

Shop_Smith_Poppi · Post by **Shop_Smith_Poppi** » Tue Jun 07, 2011 11:39 pm

SDSSmith wrote:On the sanding disc, if the 5/32 allen wrench fits, then it is a Mark V or later version. If it is 3/16" it is from a 10E/10ER. If the pulley is about 5" in diameter with a 3/4" bore, it could be the jointer drive pulley from a 10E/10ER.

Ill check the size tomorrow thanks for the info.