Marine Lumber

judaspre1982 · Post by **judaspre1982** » Sat Jul 16, 2011 11:21 am

================================

jbooher · Post by **jbooher** » Sat Jul 16, 2011 8:17 pm

Shipwright is correct in that I used 6 oz fiberglass cloth instead of mat. Inclosed is a picture of my boat.

Second try.

shipwright · Post by **shipwright** » Sun Jul 17, 2011 1:01 am

Sweet little boat.

Paul M

osx-addict · Post by **osx-addict** » Sun Jul 17, 2011 1:23 am

My little brother runs a paddling forum and some of the guys on there construct their own paddles, boats and whatnot.. Feel free to check it out -- here

horologist · Post by **horologist** » Sun Jul 17, 2011 3:29 pm

Great, 6 oz. glass cloth set in System Three Silvertip Laminating Resin it is. I will file this away for the future.

The breadth of knowledge in this group is a wonderful thing.

Thanks All,
Troy

wannabewoodworker · Post by **wannabewoodworker** » Fri Jul 29, 2011 12:03 am

Well just as an update I finished my little compartment project for the leaning post on my boat. It came out acceptable but as I am extremely anal it was not perfect and I am still learning the intricacies of "woodworking" in general. I used my Bosch router to create the rabbets for the sides and the ends. I only had a 3/4" straight bit so this had to be done in two passes on all of the pieces but it went as well as i could of expected. I wanted to use my Rigid TS 3650 and my dado blade but it doesn't make me feel all warm and fuzzy when i use it. It is a Mibro blade i bought at the local box store and although it does cut dadoes it doesn't do a very good job of it and it is a pain in the ass to setup not to mention the Rigid has a pretty short arbor so using it for wide dadoes is a bit on the scary side. I went with the 1" thick material I think mostly out of inexperience building things and I think now that it is done I could have gotten away with 3/4" material and cut 1/2" dadoes leaving 1/4" for the screws but I just wasn't sure not having done this before and doing it all from scratch with plans I made on Sketchup I was flying by the seat of my pants. This was just a basic box really with a couple of mounting ears on the ends to bolt it into the leaning post. As I said it came out passable and very functional which was the intent really it ain't fine furniture. I will try and take a couple of pics tomorrow.