Posted: Fri May 25, 2012 12:23 am
Here are some of the ones I did today. BAD pitting on the Greenies bench tubes, but oh well, I'm just being too picky.
I've been operating lathes (metal and sometimes wood) for nigh onto 35 years and have pretty quick reflexes. I've seen enough accidents by others that could've been avoided. It can get ugly. Oh, and I have spilled a drop or two of blood as well over the years. But let's not go there.
Oh and before someone asks, yes this is one of my 1956 models and those are 1.875 bench tubes.
I've been operating lathes (metal and sometimes wood) for nigh onto 35 years and have pretty quick reflexes. I've seen enough accidents by others that could've been avoided. It can get ugly. Oh, and I have spilled a drop or two of blood as well over the years. But let's not go there.
Oh and before someone asks, yes this is one of my 1956 models and those are 1.875 bench tubes.
