Page 2 of 2
Re: Bandsaw setup correctly=no blade drift!
Posted: Mon Nov 30, 2015 10:13 am
by JPG
kittyboy wrote:gullet centering is critical. put the most tension right behind the blade. this give's your blade teeth a fighting chance at pointing the right direction when you shove a little work at em. no max tension @ center of blade behind gulletts, no talking about straight cut yet
It appears someone has not discovered that the SS bandsaw differs. The wheels are not crowned. The back of all blades regardless of size ride at the same location on the wheel.
Re: Bandsaw setup correctly=no blade drift!
Posted: Mon Nov 30, 2015 10:15 am
by kittyboy
lord.
Re: Bandsaw setup correctly=no blade drift!
Posted: Mon Nov 30, 2015 10:18 am
by kittyboy
your leaving a few subjects out that just may apply to some of the rest of us. thats wonderful for you and your conditions.
Re: Bandsaw setup correctly=no blade drift!
Posted: Mon Nov 30, 2015 8:17 pm
by JPG
kittyboy wrote:your leaving a few subjects out that just may apply to some of the rest of us. thats wonderful for you and your conditions.
If you would care to elaborate on the 'subjects left out' I would be quite happy to fill in the gaps assuming I know how. If not there are others here who also are agreeable to sharing.
Understand the SS bandsaw is quite different. I already mentioned the major differences. Not realizing those differences gets one in trouble if following typical advice etc. Hence it is necessary to point those out when it becomes apparent one is not aware of them.
At times some of us get hilarious, but not when the previous paragraph becomes the subject.
I am curious at what you found to be hilarious a few posts back.

Re: Bandsaw setup correctly=no blade drift!
Posted: Wed Feb 10, 2016 7:35 am
by kittyboy
thank you for the lesson.
Re: Bandsaw setup correctly=no blade drift!
Posted: Wed Feb 10, 2016 11:27 am
by JPG
kittyboy wrote:thank you for the lesson.
You are not the first(nor I dare say not likely to be the last).
Sadly well intentioned suggestions by folks not familiar with the unique design of the SS bandsaw have caused great consternation and just plain mangling of them.
The video which started this thread is an example. It was not created with the SS bandsaw design in mind, but was intended for more 'typical' bandsaw owners.
It is quite understandable that your initial reaction was 'hilarious'. Understandable if one assumes ignorance.
I take quite seriously the need and responsibility to 'correct' those who do not 'understand'.
So welcome to the 'enlightened'.

Re: Bandsaw setup correctly=no blade drift!
Posted: Wed Feb 10, 2016 2:09 pm
by kittyboy
well, it is good of you to bestow upon an ignorant peasant your "enlightened ones" truths. thank you so
Re: Bandsaw setup correctly=no blade drift!
Posted: Wed Feb 10, 2016 2:12 pm
by kittyboy
watch out, your gunna learn something from these guys here.