Shopsmith Forums

Posted: **Wed Aug 06, 2014 12:36 pm**

rbursek wrote:Not to mention some of the toothless in KT!

As usual you are misspelling.

I do not know where the post office delivers things addressed to KT?

:D

You live in WC?

Posted: **Wed Aug 06, 2014 12:38 pm**

"WC"
Yes in a water closet!!!!!LOL

Posted: **Wed Aug 06, 2014 1:13 pm**

rbursek wrote:Also to save summer garage space, not cut the ER dedicated drill press, but shorten the support base, move the tube supports forward on the shortened base, encase ever going to horizontal, and the tubes would rest on it , between motor and table, instead of the end.
Whada ya think about that???

Here is what I did with mine. The full length tubes still rest on the support, only about 1/2 way instead of full length. Go to page 5 I believe.
Fred
https://forum.shopsmith.com/viewtopic.php?t=12319

Posted: **Wed Aug 06, 2014 11:03 pm**

Oh Fred!!,
thats what I want to do with the ER!!!!!!! Thanks for the pics!!!!

Posted: **Wed Aug 06, 2014 11:08 pm**

Can, would you give the length of the base of the ER DP??? and width of the feet at floor level?

Shopsmith Forums

Not sure which inter forum for this?