Page 2 of 3
Posted: Sat Nov 15, 2014 10:52 am
by mbcabinetmaker
This is going into a concrete room in the basement of a house. Some last minuet changes required a total redesign and a new drawing. Thanks interior designer!:mad:
[ATTACH]26882[/ATTACH]
The ceiling height had to be dropped for some lighting that was added.
[ATTACH]26883[/ATTACH]
The terracotta wine tiles are 6 pounds each or $2.00 per pound.
[ATTACH]26884[/ATTACH]
A space to store a ladder was added. A rolling ladder was a little out of the budget.
Work will continue shortly.
Posted: Sun Nov 16, 2014 5:45 pm
by mbcabinetmaker
[attach]26900[/attach]
[attach]26901[/attach]
[attach]26902[/attach]
[attach]26903[/attach]
[attach]26904[/attach]
Posted: Sun Nov 16, 2014 6:01 pm
by mbcabinetmaker
[attach]26905[/attach]
[attach]26906[/attach]
[attach]26907[/attach]
[attach]26911[/attach]
[attach]26913[/attach]
Posted: Sun Nov 16, 2014 6:06 pm
by mbcabinetmaker
[ATTACH]26914[/ATTACH]
[ATTACH]26915[/ATTACH]
[ATTACH]26916[/ATTACH]
One down!:)
Posted: Sun Nov 16, 2014 6:17 pm
by rjent
I hope someday before I die, I can do the quality work that you are showing
Absolutely first class!
Dick
Posted: Sun Nov 16, 2014 6:23 pm
by beeg
Looking good there Mark. Thanks for posting the steps.
Posted: Sun Nov 16, 2014 6:25 pm
by algale
Question: with the dado being used to create the slots for the interlocking diagonal shelves, the end of the slot is going to be an arc. Does this not matter?
Posted: Sun Nov 16, 2014 7:16 pm
by mbcabinetmaker
algale wrote:Question: with the dado being used to create the slots for the interlocking diagonal shelves, the end of the slot is going to be an arc. Does this not matter?
Most of the weight is on the back side of the shelves. I'll hide a couple of 23 gauge brads into the floaters and it will be fine.
Posted: Sun Nov 16, 2014 8:34 pm
by joedw00
Looking good Mark. Thanks for posting.
Posted: Mon Nov 17, 2014 9:42 am
by mountainbreeze
Ingenious! Nice work too.
Where did you get 3/4" plywood that is actually 3/4" thick?