Re: Man, these 10er's are HEAVY! New beast in the stable.
Posted: Thu Aug 06, 2015 4:58 pm
Yes, they are heavyfitzhugh wrote:I've wanted a 10er since I heard of them but had not seen the right deal. Last week I cleaned my shop as I began installing a dust collector, so suddenly I had room to spare [read: "stand"]. I saw an ad on cl for a 10er, seller's father was original owner, looked complete and in good shape, had speed control and many original little boxes of parts. It's in great shape as it turns out... Needs at least one bearing (I'll likely replace them all), very little rust except on the exposed ends of the tubes where the tailstock goes. I have not gone through it enough to want to run it yet but I have a motor I can use if this one is somehow doa, though po says it runs and it feels nice. Includes a while lot of smaller components like arbors, Jacobs Chuck (& key) shaper cutters, mortising chisel setup, tiny little 10(?) inch sanding disk, but it also has a flex shaft and a jigsaw. He included a black and Decker r.a.s. for free, may fix up: $125... But it sure is an odd colour:
It is either an original paint job or a very professionally done job, I suspect the latter.
SN er18668
Any suggestions on dating it?
You got a fantastic deal, lots of accessories and it certainly looks well maintained.
It is an odd colour scheme, and not one I would choose, but as they say "beauty is in the eye of the beer holder".
Regarding a date: from information put together by Skip Campbell on the Yahoo 10ER Shopsmith Users forum, late 1949 or early 1950.
There is a lot of good information on that site.
Another good source for 10ER documentation is ERdocuments
Have Fun
( Love the aluminum boys, they keep this