Page 2 of 2
Re: Power Pro is installed
Posted: Tue Feb 14, 2017 4:43 pm
by charlese
Thanks, Ron and Paul! My headstock doesn't have such a spring. My nameplate swings on an aluminum pin at the top (part #46A) to open and screws in on the bottom to close. Completely forgot about the spring held nameplate on the older headstocks.
Re: Power Pro is installed
Posted: Tue Feb 14, 2017 6:56 pm
by garys
I think you will love the extra power and the greater speed variation. Enjoy.
Re: Power Pro is installed
Posted: Tue Feb 14, 2017 9:40 pm
by JPG
The sawdust is on the top of the drawer handle.
Re: Power Pro is installed
Posted: Thu Feb 16, 2017 5:02 am
by Hobbyman2
Hobbyman2
Re: Power Pro is installed
Posted: Thu Feb 16, 2017 8:42 pm
by masonsailor2
Ok so the missing clip was not fun to retrieve. I had to remove the headstock and turn it upside down and then it fell into view and was retrieved. I tried removing the motor pan but still couldn't find it. So a little JB Weld and all is back to normal !
Paul
Re: Power Pro is installed
Posted: Wed Mar 01, 2017 7:26 am
by Sazerac81
masonsailor2 wrote:Ok so the missing clip was not fun to retrieve. I had to remove the headstock and turn it upside down and then it fell into view and was retrieved. I tried removing the motor pan but still couldn't find it. So a little JB Weld and all is back to normal !
Paul
I love JB weld, has saved my skin more than once!
Fire that baby up, it looks like a New age Beaut.
Cheers,
John