Page 2 of 2
Re: Drill Chuck in Tail Stock
Posted: Wed Nov 13, 2019 6:32 pm
by wa2crk
I like the looks of the Lee Valley one. It has a threaded end which will allow a draw bar to be used on a conventional lathe. I may have to pick one up just to have on hand.
Bill V
Re: Drill Chuck in Tail Stock
Posted: Wed Nov 13, 2019 6:41 pm
by jsburger
wa2crk wrote:I like the looks of the Lee Valley one. It has a threaded end which will allow a draw bar to be used on a conventional lathe. I may have to pick one up just to have on hand.
Bill V
Yes, very nice and half the price of the SS version. It would be easy to fabricate a draw bar for a MK-V or 10ER tail stock if necessary. Probably not needed for the tail stock but...
Re: Drill Chuck in Tail Stock
Posted: Thu Nov 14, 2019 11:17 pm
by dannyshamoon
Re: Drill Chuck in Tail Stock
Posted: Fri Nov 15, 2019 5:40 am
by Hobbyman2
? Harbor freight
https://www.harborfreight.com/search?q= ... e%20center https://www.harborfreight.com/search?q=mt2%20chuck I have one of each that work fine if you just want the arbor I got one from Ebay or SS for a new one .