Shopsmith Forums

Posted: **Fri Apr 03, 2020 5:39 pm**

As I said before in a previous post

The new SS Molder Head (556213) uses different thickness cutters and the head itself no longer has a set screw for direct attachment to the spindle. It must use an arbor and an arbor is required on even the old heads to use on the model 510/505/520/M7 with the lower guard in place.

Posted: **Fri Apr 03, 2020 8:15 pm**

Soooooo we think this is an old one. I'll have to measure the grooves and see what thickness it is this weekend. Thanks guys.

Posted: **Mon Apr 06, 2020 12:32 pm**

Mine measured out at 1/8" so I have an older model. Thanks guys.

Posted: **Thu May 07, 2020 1:23 am**

Spooner wrote:Can anyone tell me if this is the newer head or the older head?

As i know it is the new head because in the older one they have little holes in the side corners as i guess!!

Shopsmith Forums

SS Molding Head and Craftsman Cutters

Re: SS Molding Head and Craftsman Cutters

Re: SS Molding Head and Craftsman Cutters

Re: SS Molding Head and Craftsman Cutters

Re: SS Molding Head and Craftsman Cutters