Page 2 of 3
Re: Fence Wingnut
Posted: Thu Apr 23, 2020 8:10 am
by dusty
I expect this to be something other than gummed up threads. At least three of us have the same issue. Do we all have damaged threads. What confuses me though is the fact that I can not screw a nut onto the exposed threads. I can capture about two threads and then it locks up. The threads do not appear to be bad.
Looking forward to Ed's report.
Re: Fence Wingnut
Posted: Thu Apr 23, 2020 4:22 pm
by reible
- apart.jpg (138.54 KiB) Viewed 10142 times
Wire brush was enough to clean the threads and out it came!
Ed
Re: Fence Wingnut
Posted: Thu Apr 23, 2020 5:02 pm
by DLB
I see you also got the bit that you previously pointed to with a green arrow off. How did you do that, and is it re-usable?
My tuppence worth: while the threaded portion measures 3/8 inch and 16 TPI, it does not seem to be standard NC threads. Like others, I could not thread a 3/8 NC nut onto it. In my estimation it has something to do with the unique (?) threaded insert that is pressed (?) into the aluminum casting. (Which I also could not thread a standard 3/8 NC bolt into.) I also could not 'chase' the threads with a 3/8 NC die, it wanted to cut new portions. Which of course I did not want to do, so I stopped.
- David
Re: Fence Wingnut
Posted: Fri Apr 24, 2020 9:32 am
by dusty
Is the thread standard?
Re: Fence Wingnut
Posted: Fri Apr 24, 2020 11:09 am
by rpd
DLB wrote:I see you also got the bit that you previously pointed to with a green arrow off. How did you do that, and is it re-usable?
My tuppence worth: while the threaded portion measures 3/8 inch and 16 TPI, it does not seem to be standard NC threads. Like others, I could not thread a 3/8 NC nut onto it. In my estimation it has something to do with the unique (?) threaded insert that is pressed (?) into the aluminum casting. (Which I also could not thread a standard 3/8 NC bolt into.) I also could not 'chase' the threads with a 3/8 NC die, it wanted to cut new portions. Which of course I did not want to do, so I stopped.
- David
Is it possibly a double start thread.
Re: Fence Wingnut
Posted: Fri Apr 24, 2020 12:12 pm
by DLB
Yes, I believe double start thread is the correct answer. Thank you, rpd.
- David
Re: Fence Wingnut
Posted: Fri Apr 24, 2020 9:09 pm
by stew
I have not heard of a double start thread, can someone explain this or a picture please.
Re: Fence Wingnut
Posted: Fri Apr 24, 2020 10:14 pm
by rpd
stew wrote:I have not heard of a double start thread, can someone explain this or a picture please.
Re: Fence Wingnut
Posted: Fri Apr 24, 2020 10:19 pm
by wrmnfzy
I read the description and saw pictures on the web and I still don’t understand the purpose or much else about it, color me hopeless
!
Re: Fence Wingnut
Posted: Fri Apr 24, 2020 10:48 pm
by rpd
wrmnfzy wrote:I read the description and saw pictures on the web and I still don’t understand the purpose or much else about it, color me hopeless
!
The action is twice as fast,
Look at the cap on a water bottle, which has multiple starts, and closes in a fraction of a turn,
USA 074 Two start thread(Double thread).pdf