Shopsmith Forums

swampgator wrote:Charles, this sounds like a great idea. But, I'm a bit slow on this concept. Do you have a pic on the setup? I just don't get the router chuck. That's my hold up. Thanks for your help.

Found the photo in post #16 of this thread, but no router bit or chuck attached. The first photo shows the position of the table and fence when making mortises. https://forum.shopsmith.com/viewtopic.php?t=1124&highlight=rip+fence

Here are the Shopsmith router chucks - there is one for 1/4" shanked bits and one for 1/2" shanks. The 1/2" chuck is shown with the shield and the 1/4" is on the right side. http://www.shopsmith.com/ownersite/catalog/rm_routerchuckshield.htm

Thanks, Charles. I have a 500 machine and all these attachments. Will do some experimentation. Will return if I have more questions. Thanks again.