Page 2 of 2
Posted: Mon Jan 16, 2012 11:32 pm
by JPG
fiatben wrote:Red, you crack me up!!
On a more serious note (or maybe not, but this is what popped into my head) couldn't you do that cove thing on the table saw? You know, the thing where you run it over the blade at an angle? (I could go look it up in the book, but I'm just too lazy right now.)
I think he needs a fairly small radius.
Posted: Tue Jan 17, 2012 7:37 am
by mbcabinetmaker
[quote="JPG40504"]If yer gonna take the 'cost effective' route, carve it out with a gouge!]
A router bit cost less than a good gouge!:eek:
Posted: Tue Jan 17, 2012 12:04 pm
by farley
going the router bit way, a gouge is used by purist but I know I would wreak a project using that.
buying a router bit is also the way to build up your router bit collection.
thanks guys
Posted: Tue Jan 17, 2012 12:48 pm
by mbcabinetmaker
farley wrote: but I know I would wreak a project using that.
How do you think it got the name
Gouge?:D
Posted: Tue Jan 17, 2012 1:55 pm
by JPG
[quote="mbcabinetmaker"]A router bit cost less than a good gouge!:eek: ]
I assumed he already had a gouge!;)