Page 3 of 3
Re: Maple Logs
Posted: Sat Apr 01, 2017 7:14 pm
by swampgator
thunderbirdbat wrote:I have used draw knives for this. I believe this is the way it was done in the past.
Thank you, Brenda. Had not considered, but then you need some way to anchor the wood to be able to use the knife. Hmmmm! Something to think on.
Just a personal tip, I purchased a garbage of about 40 gallons to put in wood that is not debarked. It does a pretty good job on slowing down the drying process, also. Going to open up and give a report. Wish me luck.
Dan and Hobbyman, I wish you both luck and look forward to your projects.
Steve, the old Florida gator
Re: Maple Logs
Posted: Sat Apr 01, 2017 7:36 pm
by thunderbirdbat
swampgator wrote:thunderbirdbat wrote:I have used draw knives for this. I believe this is the way it was done in the past.
Thank you, Brenda. Had not considered, but then you need some way to anchor the wood to be able to use the knife. Hmmmm! Something to think on.
Just a personal tip, I purchased a garbage of about 40 gallons to put in wood that is not debarked. It does a pretty good job on slowing down the drying process, also. Going to open up and give a report. Wish me luck.
Dan and Hobbyman, I wish you both luck and look forward to your projects.
Steve, the old Florida gator
Large logs do not move much since the weight is larger than the force applied and you are going along the log not around it. Small pieces are usually held in a shaving horse or vise.