Page 3 of 3
Re: 501337 CAM - Control, Shop Smith Mark VII
Posted: Tue Oct 22, 2024 8:20 am
by jafpanda
CS response will be 'interesting".
No real surprises. I didn’t expect they hang on to stuff that had a short run in the 60’s
- IMG_6738.jpeg (134.05 KiB) Viewed 2957 times
Re: 501337 CAM - Control, Shop Smith Mark VII
Posted: Tue Oct 22, 2024 12:44 pm
by chapmanruss
At least they are recommending the Forum for answers they don't have.
Re: 501337 CAM - Control, Shop Smith Mark VII
Posted: Tue Oct 22, 2024 3:29 pm
by jafpanda
Just got a 3D printed CAM back. Looks good enough as compared to two different factory made original injected molded parts.
How do I upload the STL file for anyone interested?
Photos poorly show side-by-side comparison. The blue one is a 3D printed STL.
The one with discoloration is from my dads Mark VII which was repaired with epoxy.
…
- IMG_6752.jpeg (85.6 KiB) Viewed 2929 times
- IMG_6751.jpeg (118.75 KiB) Viewed 2929 times
- IMG_6750.jpeg (245.75 KiB) Viewed 2929 times
- IMG_6748.jpeg (545.77 KiB) Viewed 2929 times
Re: 501337 CAM - Control, Shop Smith Mark VII
Posted: Thu Oct 24, 2024 9:36 am
by jafpanda
..
..
How do I upload the STL file ?
..
..
Re: 501337 CAM - Control, Shop Smith Mark VII
Posted: Thu Oct 24, 2024 10:21 am
by admin
Please try again. I have added stl to the list of document types, which is what I believe will cause the system to allow it
Re: 501337 CAM - Control, Shop Smith Mark VII
Posted: Thu Oct 24, 2024 10:34 am
by jafpanda
.
Here is the STL file used to fabricate the blue "CAM Control" PN 501337 pictured in this thread.
.
(although the icon shows it as a pdf attachment... it's not a pdf.)
There is a free 3D viewer online at
https://3dviewer.net/
.
Re: 501337 CAM - Control, Shop Smith Mark VII
Posted: Thu Oct 24, 2024 3:56 pm
by JPG
That is a spitting image of the cnc created aluminum cam I have (hopefully with straighter control shaft hole).