Posted: Tue Dec 08, 2009 8:23 am
BlueKayak,
It looks like you were half way to making a rolling pin. http://www.turnedtreasures.com/pdf_page ... in_pdf.pdf
From looking at your photos, watch the distance from the tool rest to the work. It should be about 1/8 inch to give the tool good support. Keep up the practice.
It looks like you were half way to making a rolling pin. http://www.turnedtreasures.com/pdf_page ... in_pdf.pdf
From looking at your photos, watch the distance from the tool rest to the work. It should be about 1/8 inch to give the tool good support. Keep up the practice.