Page 3 of 3
Posted: Wed May 12, 2010 10:59 am
by JPG
anmius wrote:I built my own and the design I chose is shown on ebay with the parts. I am very pleased with it and it does all I need (including an 8 foot board). It does take a couple of minutes to tweak but works fine Do an ebay search for this item number: 320526117164
This be quicker!:D
http://cgi.ebay.com/Outfeed-Table-Compatible-w-all-Shopsmith-Models-/320526117164?cmd=ViewItem&pt=LH_DefaultDomain_0&hash=item4aa0d8692c
Posted: Wed May 12, 2010 11:14 am
by ldh
For the folks that want to build their own out-feed (Mark V 500) table I just found some of the component pics of one I built.
ldh
[ATTACH]8849[/ATTACH]
[ATTACH]8850[/ATTACH]
[ATTACH]8851[/ATTACH]
[ATTACH]8852[/ATTACH]
Posted: Wed May 12, 2010 11:15 am
by wlhayesmfs
Has anyone purchased this hardware kit and built it to see if it does what he says it does? Would love to hear from anyone that did one way or the other.
Thanks
Posted: Wed May 12, 2010 11:16 am
by ldh
Out-feed table pics.
ldh
[ATTACH]8853[/ATTACH]
[ATTACH]8854[/ATTACH]
[ATTACH]8855[/ATTACH]
[ATTACH]8856[/ATTACH]
Posted: Wed May 12, 2010 2:50 pm
by anmius
wlhayesmfs wrote:Has anyone purchased this hardware kit and built it to see if it does what he says it does? Would love to hear from anyone that did one way or the other.
Thanks
Yes, I have. Just remember what you are buying is a "bag of bolts" and some plans. Yes, it does mount to the 500 (or 505/510/520) and doesn't sit on the floor. Yes, it can be adjusted to a varying height of the table but it has to be done manually, it doesn't follow the table up and down. And it will tip with the table but not for the whole range (I normally don't rip a mitered edge). And the plans don't call for slots to allow for the miter bar (which could be added if you wish). But since I only use it for ripping, I don't use the miter bar. For me it was a quick and inexpensive solution since I already had the wood needed (MDO).
Worth the price for me.