Shopsmith Forums

Good study and report, Dusty! ATTA BOY!!:D

Take care!

dusty wrote:...Disclaimer: All of these measurements were made assuming that your Shopsmith was sitting on something like a concrete shop floor. If longer pieces must be cut, simply move your Shopsmith to the edge of a loading dock (as an example) and length is limited only by distance to the ground as measured on the tilt. If still greater length is required, well……

Or hows about tilting the SS? Lift the right end and place it on a couple of sturdy automotive jack stands or a solid platform made from scrap?
How tall are you?