Page 4 of 7
Re: Miterset official SS Accessory
Posted: Tue May 17, 2016 5:53 pm
by masonsailor2
Yes I was aware JPG. I was just hoping against hope that mine had been shipped with the corrected pieces. But alas I just received the email to discard them when they arrive and new ones will be coming. Oh well. As usual the MS is handling it all very professionally and so no big deal.
Paul
Re: Miterset official SS Accessory
Posted: Tue May 17, 2016 9:54 pm
by Skizzity
Re: Miterset official SS Accessory
Posted: Thu May 26, 2016 7:29 pm
by moggymatt
Anyone get their replacement yet?
Re: Miterset official SS Accessory
Posted: Fri May 27, 2016 6:50 am
by rlkeeney
I've not received my first one yet.
Re: Miterset official SS Accessory
Posted: Fri Jun 24, 2016 6:52 pm
by moggymatt
Whoo-Hooo. Got my replacement parts today!
Re: Miterset official SS Accessory
Posted: Fri Jun 24, 2016 7:24 pm
by masonsailor2
They gave a delivery date of today so hopefully when I get home it will be there.
Re: Miterset official SS Accessory
Posted: Fri Jun 24, 2016 7:38 pm
by moggymatt
masonsailor2 wrote:They gave a delivery date of today so hopefully when I get home it will be there.
What's your 1st project with it going to be?
Re: Miterset official SS Accessory
Posted: Fri Jun 24, 2016 8:45 pm
by JPG
moggymatt wrote:masonsailor2 wrote:They gave a delivery date of today so hopefully when I get home it will be there.
What's your 1st project with it going to be?
Set the miter gauge stops!
Re: Miterset official SS Accessory
Posted: Mon Aug 01, 2016 1:22 pm
by larryhrockisland
I noticed on the manufacturer website that these are available for common 3/4 width miter gauges. Would the shopsmith miter gauge align correctly in the 3/4 slot as long as it was held against one side? I have an ER, 500,520 and an old craftsman table saw. It would be nice to use the miterset on any of them.
Re: Miterset official SS Accessory
Posted: Mon Aug 01, 2016 3:58 pm
by JPG
larryhrockisland wrote:I noticed on the manufacturer website that these are available for common 3/4 width miter gauges. Would the shopsmith miter gauge align correctly in the 3/4 slot as long as it was held against one side? I have an ER, 500,520 and an old craftsman table saw. It would be nice to use the miterset on any of them.
Almost.
Shimmed equally both sides - likely.