Shopsmith Forums

dusty wrote:Wow, talk about "long winded".

i REALLY THINK YOU GUYS SHOULD CARRY ON THREADS LIKE THIS OVER ON THE FESTOOL SITE.

Where were thee 3 month ago?

JPG wrote:

dusty wrote:Wow, talk about "long winded".

i REALLY THINK YOU GUYS SHOULD CARRY ON THREADS LIKE THIS OVER ON THE FESTOOL SITE.

Where were thee 3 month ago?

I don't know where I was but I certainly was not reading a long winded thread that spoke of nothing but FESTOOL.

dusty wrote:

JPG wrote:

dusty wrote:Wow, talk about "long winded".

i REALLY THINK YOU GUYS SHOULD CARRY ON THREADS LIKE THIS OVER ON THE FESTOOL SITE.

Where were thee 3 month ago?

I don't know where I was but I certainly was not reading a long winded thread that spoke of nothing but FESTOOL.

Dusty,

I notice that you never complained about Festool threads started by reible or sehast on this forum in the past...only about a thread that I started. Hmmm, coincidence? If it bothers you so much, I do believe you have the power to delete the entire thread.

Chill!!!! Both of thee.

Most of the wind was about particle counters!!!!

Not of interest to all, but it is to some.

Y'all getting stir crazy?

This too shall pass!

Chill?? You are kidding! I have been relatively quiet for weeks, maybe months AND this too could pass!!!

dusty wrote:Chill?? You are kidding! I have been relatively quiet for weeks, maybe months AND this too could pass!!!

>0

Dusty,

You sure know how to suck all of the oxygen out of a room. Since you seem to want to edit/alter the threads where I am the OP, perhaps you can publish a list of topics that are allowed for me to post on and which are to be banned. Oh mighty CENSOR, I await your edict.

>>>>0

dusty wrote:Wow, talk about "long winded".

i REALLY THINK YOU GUYS SHOULD CARRY ON THREADS LIKE THIS OVER ON THE FESTOOL SITE.

Finally catching up on some old threads, dusty?

I’ve gotta disagree with you on this one. I’m always learning something from the technical diversity. And to quote the official forum description:

“Create a review for a woodworking tool that you are familiar with (Shopsmith brand or Non-Shopsmith) or just post your opinion on a specific tool. Head to head comparisons welcome too.”

BuckeyeDennis wrote:

dusty wrote:Wow, talk about "long winded".

i REALLY THINK YOU GUYS SHOULD CARRY ON THREADS LIKE THIS OVER ON THE FESTOOL SITE.

Finally catching up on some old threads, dusty?

I’ve gotta disagree with you on this one. I’m always learning something from the technical diversity. And to quote the official forum description:

“Create a review for a woodworking tool that you are familiar with (Shopsmith brand or Non-Shopsmith) or just post your opinion on a specific tool. Head to head comparisons welcome too.”

Thank you for that feedback and for the referenced quotation.