Shopsmith Forums

Posted: **Wed Sep 09, 2009 9:17 pm**

dusty wrote:... how much saw blade wobble I can accept, ...

Just struck me: if a wobble blade is perfectly all right to use to cut dado and groove, why not just consider the wobble in a regular blade as the "kerf width" adjustment?

Posted: **Wed Sep 09, 2009 9:28 pm**

keakap wrote:Just struck me: if a wobble blade is perfectly all right to use to cut dado and groove, why not just consider the wobble in a regular blade as the "kerf width" adjustment?

Absolutely brilliant observation, keakap!!:D

Also would like to present an question to Dusty's .003" runnout. How much does that .003" effect your wood?

Posted: **Wed Sep 09, 2009 10:09 pm**

charlese wrote: Also would like to present an answer to Dusty's .003" runnout. How much does that .003" effect your wood?

As I said in post #26. There is not enough wobble on this blade to be a problem (.003").

Shopsmith Forums

Where Does One Begin?