Page 4 of 9
Re: what's the spindle knob for?
Posted: Sat Sep 05, 2020 11:28 pm
by JPG
Re: what's the spindle knob for?
Posted: Sat Sep 05, 2020 11:30 pm
by Jkroofer
- C1EA51C9-0B48-48EF-A882-3CC0979629FF.jpeg (47.71 KiB) Viewed 2977 times
- C1EA51C9-0B48-48EF-A882-3CC0979629FF.jpeg (47.71 KiB) Viewed 2977 times
- B81D334B-0CAC-4457-8785-06B7F2380BF4.jpeg (43.53 KiB) Viewed 2977 times
Re: what's the spindle knob for?
Posted: Sat Sep 05, 2020 11:33 pm
by Jkroofer
Weird retaining rings, not lock washers. Sorry. There’s one in the back? On the inside? Going to look now. I was wondering where that one went. Lol
Re: what's the spindle knob for?
Posted: Sat Sep 05, 2020 11:36 pm
by Jkroofer
- C57368A1-3FF1-462F-901C-0B44AFC24347.jpeg (87.61 KiB) Viewed 2977 times
Weird retaining rings, not lock washers. Sorry. There’s one in the back? On the inside? Going to look now. I was wondering where that one went. Lol
Here??? I don’t see a groove for it.
Re: what's the spindle knob for?
Posted: Sat Sep 05, 2020 11:38 pm
by Jkroofer
Nevermind. I see / feel it. I’ll remove the drive sleeve, install the back one, reinstall, and put the front one back in place. That should solve that issue. Now to find that collar
Re: what's the spindle knob for?
Posted: Sat Sep 05, 2020 11:51 pm
by Jkroofer
How bout that! I was actually able to get it seated in without removing the drive sleeve.
Re: what's the spindle knob for?
Posted: Sat Sep 05, 2020 11:53 pm
by JPG
Good Boy! Now talk to Tony!
Re: what's the spindle knob for?
Posted: Sun Sep 06, 2020 2:43 pm
by Jkroofer
Re: what's the spindle knob for?
Posted: Sun Sep 06, 2020 4:43 pm
by JPG
NO.
FWIW I just bought 10 unplated for $0.64 each for a different purpose.
The knurled collar has an extension that bears against the inner race of the bearing and thus acts as a shaft end play preventer.
Repeat the Tony mantra and give him more time to reveal the location of the errant collar.
Fear not there
are other sources. (used)
Re: what's the spindle knob for?
Posted: Mon Sep 07, 2020 9:28 am
by Jkroofer
I remember seeing a post that shows that there are differences between the collars of the older single bearing quill and the 2 bearing quill that I have. I found one used on eBay and purchased it as it was fairly inexpensive but I’m not sure which one it is. I guess I have a 50/50 shot of getting the right one. Tony has unfortunately been no help. If you know where I can purchase one and be confident that it’s the correct part, can you send me a link?