Posted: Sat Nov 12, 2011 5:03 am
Truly an elegant solution.macgyver wrote:My SS lives in a 3 car garage with 3 drains. Needless the say, not a level flat floor to be found anywhere in my "Shop". I never had a problem with table alignments but more with the instability of the SS. My answer to this problem was the addition of leveling feet to the legs. As shown in the attached photo. It is a 1 1/2 inch by 3 inch hardwood block with threaded inserts and a 7 inch bolt with a rubber foot threaded through it. When I want to work, I position my SS where I need it screw down the foot or feet to provide a level stable saw.