Page 1 of 1
Troubleshooting
Posted: Fri Mar 30, 2012 10:44 pm
by bduemig
I am trying to troubleshoot a possible bearing that may be going bad in my Mark V. Can I remove the Quill and run the motor to isolate the quill bearings?
Posted: Fri Mar 30, 2012 11:45 pm
by damagi
bduemig wrote:I am trying to troubleshoot a possible bearing that may be going bad in my Mark V. Can I remove the Quill and run the motor to isolate the quill bearings?
You can do that. you could also remove the belt from the motor to the idler shaft and see what you hear.
Posted: Sat Mar 31, 2012 12:05 am
by JPG
I prefer to 'feel' the bearings rather than listen to them.
Does require removal!
Troubleshooting
Posted: Sat Mar 31, 2012 5:06 am
by dusty
bduemig wrote:I am trying to troubleshoot a possible bearing that may be going bad in my Mark V. Can I remove the Quill and run the motor to isolate the quill bearings?
Yes, you can run the machine with the quill removed. With the quill removed just be careful that you do not let loose of the quill handle without locking it. If you do you will likely be reinstalling the quill spring. That can be a task to avoid.
