Shopsmith Forums

I recently acquired a few Mark 2 parts including a work table. The table is the same width as a Mark 5 table, but is shallower by 1" and has a different fence rail on the front.

[ATTACH]18512[/ATTACH]

First alteration is to mount the original rail upside down.

[ATTACH]18513[/ATTACH]

Next a Mark 5 rail is screwed onto the Mark 2 rail.

[ATTACH]18514[/ATTACH]

The next post will show the table rear changes.

The table is 1" shorter front to rear. It has a tapped hole in the center that has 1/4 - 28 threads.

[ATTACH]18515[/ATTACH]

I attached a 1x1 wood spacer to the rear with a 1/4-28 cap screw. Notice the miter bar clearance notches. I may use carpet tape to prevent shifting position since only the screw in the center holds it in place. Eventually the wood spacer may be replaced with an aluminum bar.

[ATTACH]18516[/ATTACH]

Lastly a Mark 5 fence now functions with the Mark 2 table. I may need to shim the Mark 5 rail from the looks of this pix. The fence appears low in the front.

[ATTACH]18517[/ATTACH]

I do not know if the quill shaft is in the same location(front to rear) as a Mark 5. Time shall tell!

Some more interesting Mark 2 modifications are in the works.

Thanks to the forum member who threw the parts my way!:)

Shimming evened things out. The quill will be 1/2" closer to the front of the fence.

[ATTACH]18518[/ATTACH]

I presume the 'hole' in the table insert establishes the quill location. That and the insert itself.