Shopsmith Forums

There is a small roll pin in my parts box as I'm putting things back together. Its hard to see it on the diagram, I'm trying to remember where it goes. I remmeber there was some mistake on a thread a while back of someone thinking it was an allen head screw. I remember it just taps out...

mrhart wrote:There is a small roll pin in my parts box as I'm putting things back together. Its hard to see it on the diagram, I'm trying to remember where it goes. I remmeber there was some mistake on a thread a while back of someone thinking it was an allen head screw. I remember it just taps out...

Some dimensions might help. OD, length.

1 inch long, maybe 1/8 diameter.

mrhart wrote:There is a small roll pin in my parts box as I'm putting things back together. Its hard to see it on the diagram, I'm trying to remember where it goes. I remmeber there was some mistake on a thread a while back of someone thinking it was an allen head screw. I remember it just taps out...

What have you taken apart?

Table Height Control Handle maybe? No. That one is not 1" long.

How about the pin that goes in the shaft that holds the base arm in the base (right side of the frame)? If you had more than one, I would suggest looking at your casters.

SDSSmith wrote:How about the pin that goes in the shaft that holds the base arm in the base (right side of the frame)? If you had more than one, I would suggest looking at your casters.

Ditto!!!!!!!!!

I think its the pin that goes through the threaded rod and handle on the carrage lock.
There has been gremlins on my work bench.

mrhart wrote:I think its the pin that goes through the threaded rod and handle on the carrage lock.
There has been gremlins on my work bench.

That one would be smaller (< 1").