Hi all, first thread on the forum. I took a break from woodworking for a few years and am now ready to get started all over again.
Thinking about the Shopsmith this time, how high is the unit when it is in the drill press position?
Thanks
Looking to buy, have question
Moderator: admin
My Mark 7 is 79" in drill press position. Jimnivensid wrote:Hi all, first thread on the forum. I took a break from woodworking for a few years and am now ready to get started all over again.
Thinking about the Shopsmith this time, how high is the unit when it is in the drill press position?
Thanks
F. Jim Parks
Lakewood, Colorado:)
When the love of power is replaced by the power of love the world will have a chance for survival.
Lakewood, Colorado:)
When the love of power is replaced by the power of love the world will have a chance for survival.
nivensid wrote:...how high is the unit when it is in the drill press position?
Thanks
Welcome to the forum.
Now do you mean total height of the tubes when in drill press mode or the table height?
SS 500(09/1980), DC3300, jointer, bandsaw, belt sander, Strip Sander, drum sanders,molder, dado, biscuit joiner, universal lathe tool rest, Oneway talon chuck, router bits & chucks and a De Walt 735 planer,a #5,#6, block planes. ALL in a 100 square foot shop.
.
.
Bob
.
.
Bob
My answer assumed you desired to know the height of the tubes in drill press position. At least that would have been my question as I assume one desires to know if ceiling height would allow use of machine in drill press position. Jim
F. Jim Parks
Lakewood, Colorado:)
When the love of power is replaced by the power of love the world will have a chance for survival.
Lakewood, Colorado:)
When the love of power is replaced by the power of love the world will have a chance for survival.