Belt Sander Drive sleave material

bhurley · Post by **bhurley** » Fri Jan 18, 2013 2:33 pm

Has anyone come up with a replacement material to use for the rubber sleave that covers the drive hub on a belt sander? It is not serviceable through SS.

Thanks in advance

Bob

eartigas · Post by **eartigas** » Fri Jan 18, 2013 5:08 pm

It used to be. Did you request SS for it? I ordered one and can find the part # if you need it.

Ed

eartigas · Post by **eartigas** » Fri Jan 18, 2013 5:12 pm

502932 Drive Sleeve ... $10.57

bhurley · Post by **bhurley** » Sun Jan 20, 2013 8:09 am

Thank you very much. I am amazed - the last time I inquired about this part Jan told me that it was not available as a component. She said I would have to buy the $100 assembly.

Thank you very much for the great news.

dusty · Post by **dusty** » Sun Jan 20, 2013 8:18 am

bhurley wrote:Thank you very much. I am amazed - the last time I inquired about this part Jan told me that it was not available as a component. She said I would have to buy the $100 assembly.

Thank you very much for the great news.

Don't rejoice until you have placed an order and been given an indication that it will ship. Actually, you probably should not rejoice until you have recived it.

The current catalog clearly indicates it to not be a "replacement part".

If I were you, I would order online and wait patiently.

JPG · Post by **JPG** » Sun Jan 20, 2013 8:47 am

dusty wrote:Don't rejoice until you have placed an order and been given an indication that it will ship. Actually, you probably should not rejoice until you have recived it.

The current catalog clearly indicates it to not be a "replacement part".

If I were you, I would order online and wait patiently.

Very patiently!