Shopsmith Forums

The Mark VII extension table has both a horizontal and a 'vertical' rail for attaching the rip fence. More about that below.

[ATTACH]21156[/ATTACH]

Both short rails are attached with two screws and washers like the main table rail.

[ATTACH]21157[/ATTACH]

One of them 'off'.

[ATTACH]21158[/ATTACH]

The posts are not 'detachable'.

[ATTACH]21159[/ATTACH]

This thread is linked to from https://forum.shopsmith.com/viewtopic.php?t=11373

Now about that extra rail.

The extension table not only mounts like a Mark 5/V/7 extension table to the base end, but also can 'extend' the main table width.

[ATTACH]21162[/ATTACH]

Notice that the extension table post interfere with the saw blade when positioned near the main table. The 'extra' blade slot allows sawing with the tables adjacent.

[ATTACH]21163[/ATTACH]

[ATTACH]21164[/ATTACH]


Hmmmmm My pix limit was 5.