Page 1 of 1
Curious-Power Pro upgrade Question
Posted: Sat Jan 11, 2014 10:35 am
by chucks
Has anyone upgrade the old Mark VII to the Power Pro?
Posted: Sat Jan 11, 2014 11:07 am
by JPG
chucks wrote:Has anyone upgrade the old Mark VII to the Power Pro?
One would have to fabricate different mounts for the motor and control board.
The control panel mounting also.
The spear would have to go bye-bye.
The idler shaft may present problems(the eccentric od is larger on the VII).
As a first look that is what I see as 'issues' to be resolved as seen from afar.
Interesting thought!!!
Posted: Sun Jan 12, 2014 12:53 pm
by chucks
Thank you Sir.....;the Power Pro weight would probably have been to much for the old rack on the Mrk VII anyway.(Would have been nice though.)
Posted: Sun Jan 12, 2014 4:45 pm
by JPG
chucks wrote:Thank you Sir.....]the Power Pro weight would probably have been to much for the old rack on the Mrk VII anyway[/B].(Would have been nice though.)
Why????
The Mark V/7 tubes are thinner IIRC. At the very least they are the same!
Posted: Sun Jan 12, 2014 7:44 pm
by chucks
I was referring to the plastic rack(Gear track or what ever the proper name is) Moving the addition wight of the Power Pro headstock using it may have ended it's life a bit quickly.
Posted: Sun Jan 12, 2014 10:39 pm
by JPG
chucks wrote:I was referring to the plastic rack(Gear track or what ever the proper name is) Moving the addition wight of the Power Pro headstock using it may have ended it's life a bit quickly.
I doubt that 'extra' weight would affect it.
However they do get 'brittle'.
