I took my Shopsmith Mark V (1983) apart to change the sheave and bearing. When I got it, it was almost seized up completely. My problem is, when I put it back together, how do I synchronize the speed controller with the speed of the headstock?
I haven't got my sheave yet and ,at my age, I forgot if it was on slow or high. Is there a rule of thumb to putting it back together? I took the speed controller apart and have it all cleaned and ready to put back together as soon as I get the part.
Thanks for anything that you can suggest. Kaynyne
Speed Control
Moderator: admin
-
ChrisNeilan
- Platinum Member
- Posts: 1463
- Joined: Sun Oct 27, 2013 5:30 pm
- Location: Waterford, Connecticut
- Contact:
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Regardless of whether a 'high speed adjustment' is made, the speed control is adjusted to the high speed stop just before attaching the ring(set to fast) and control knob.
The control needs to be set to fast to install the motor belt(next).
The high speed adjustment can be done at any time. IIWM, I would not do that until it is completely reassembled.
The control needs to be set to fast to install the motor belt(next).
The high speed adjustment can be done at any time. IIWM, I would not do that until it is completely reassembled.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Here's a how to speed adj.
[ATTACH]24072[/ATTACH]
[ATTACH]24072[/ATTACH]
- Attachments
-
how to do a high speed adjustment.PDF- (382.25 KiB) Downloaded 363 times
SS 500(09/1980), DC3300, jointer, bandsaw, belt sander, Strip Sander, drum sanders,molder, dado, biscuit joiner, universal lathe tool rest, Oneway talon chuck, router bits & chucks and a De Walt 735 planer,a #5,#6, block planes. ALL in a 100 square foot shop.
.
.
Bob
.
.
Bob
Thanks for all the help. I'm sure I can handle it. I know the people at Shopsmith are great to work with, but I didn't realize that once I bought a Shopsmith that I joined a family of great people, too. Thanks again for all the help, and I know not to be afraid to ask for help again. Thanks for everything, Kaynyne