Page 1 of 1
IPM-1 Jointech
Posted: Fri Mar 07, 2014 11:35 am
by dgreen810
Does anyone on this forum use the IPM-1 by Jointech fence for your table saw fence on a MK 5. If so what is your opinion? I have been using mine as a router fence, even used it with my drill press and radial arm saw.
I have the old original Incra Jig I use as well on occasion on my free standing drill press.
Don G
Posted: Sat Mar 08, 2014 2:35 pm
by Gene Howe
Don't know if it's an I-PM. Mine's the one they built for the Shopsmith MKV.
I use it as the TS fence and router fence. It's a great piece of equipment.
Once the rails were attached, no other fence will work. And, without those rails, it can't be used any where else.
Posted: Sat Mar 08, 2014 3:43 pm
by dgreen810
If you go to my site at
http://www.picturetrail.com/smoke810 and look at the Tormek album, the picture showing all the carving knives, they are on the router table with the IPM-1 (Incremental positioning machine) on the right of the router insert.
edit: I just moved two more photos in the same album at the bottom of the list,
Don G
Posted: Sat Mar 08, 2014 4:49 pm
by Gene Howe
Don,
Here's a picture of what I have. Except mine is a 500.
Not the same as yours. Sorry.
[ATTACH]24279[/ATTACH]
Re: IPM-1 Jointech
Posted: Fri Jan 13, 2017 3:05 pm
by ecom1
dgreen810 wrote:Does anyone on this forum use the IPM-1 by Jointech fence for your table saw fence on a MK 5. If so what is your opinion? I have been using mine as a router fence, even used it with my drill press and radial arm saw.
I have the old original Incra Jig I use as well on occasion on my free standing drill press.
Don G
Hey Don, I just PM'd you regarding this thread.