Page 1 of 1
New to me Power Stand
Posted: Fri Jun 19, 2015 1:33 am
by whsewardiv
I just acquired an older "machine specific" power stand, with the older style jig saw. I was wondering if it's possible to use it with the newer style scroll saw, and if so what will I need to make it work. And...if anyone has a copy of the manual for it, I'd be greatful for a copy
Thanks
Re: New to me Power Stand
Posted: Fri Jun 19, 2015 10:08 am
by joedw00
Picture would help. Part#?
Re: New to me Power Stand
Posted: Fri Jun 19, 2015 10:37 am
by JPG
AAUI, the differences between different SPTs is the pulleys that determine speed. They all mount in the 'SPT mount.
However there is a scroll saw specific power stand. I think that has to do with the self power version.
Lotta conjecture!!!
Re: New to me Power Stand
Posted: Fri Jun 19, 2015 10:48 am
by BuckeyeDennis
Shopsmith's
Pulley Guard Manual gives the belt and pulley info needed to adapt the Power Stand to almost any SPT, including the scroll saw.
Re: New to me Power Stand
Posted: Mon May 16, 2016 8:18 pm
by whsewardiv
anyone know where i can get the 4 step pulleys for this...the mother ship no longer carries...
Re: New to me Power Stand
Posted: Mon May 16, 2016 8:31 pm
by BuckeyeDennis
whsewardiv wrote:anyone know where i can get the 4 step pulleys for this...the mother ship no longer carries...
It looks like you can order them from
McMaster Carr.
Re: New to me Power Stand
Posted: Mon May 16, 2016 8:35 pm
by ERLover
BuckeyeDennis wrote:whsewardiv wrote:anyone know where i can get the 4 step pulleys for this...the mother ship no longer carries...
It looks like you can order them from
McMaster Carr.
BD they are my best friend and it shows up in 2 days unless a weekend is involved!!!
Re: New to me Power Stand
Posted: Tue May 17, 2016 12:37 am
by whsewardiv
awesome thanks will order in the am