Page 1 of 1
10er small jointer cutterhead..must be missing something
Posted: Tue Jun 23, 2015 5:46 pm
by robster
- 025.JPG (127.04 KiB) Viewed 1407 times
On the 10er I have these 3 pieces in the photo. The arbor I thought would fit the little jointer cutter head but its not long enough or thick enough. What am I missing here. I looked at the old 10er catalog and this seems to be the right part but no...
Re: 10er small jointer cutterhead..must be missing something
Posted: Tue Jun 23, 2015 9:45 pm
by JPG
The cutter will mount directly on the quill shaft.
If you insist on using an arbor, a 5/8" long enough one is required.
Re: 10er small jointer cutterhead..must be missing something
Posted: Tue Jun 23, 2015 9:58 pm
by robster
Duh, your right! Now that I look closer at the intructions I see it is directly mounted to the quill shaft...My bad. Thanks!